Right in the middle of ultralight and overbuilt is where you'll find our Sheep Mountain tents. Made of durable and lightweight Oxford polyester, these versatile tents will thrive in arid desert canyons, high elevation alpine forests, and everything in between. Two doors and two vestibules provide easy entry and exit, ample dry space to store gear, and extra ventilation on warmer nights. Color coded webbing and buckles make set up easier, and eight interior mesh pockets keep all your accessories organized and within an arms reach.
Features two doors and two vestibules Doors have two closure options: Zip up mesh door for ventilation or zip up the breathable layer for full protection Fly vents allow for venting in inclement weather
Storm flaps on vestibule zipper
Beefy #10 YKK Zipper
Color coded webbing and buckles
Velcro® tabs connect fly to pole structure providing perfect pitch and extra stability
Ready to pitch; with pre-cut guy lines and tensioners attached to fly
Tent and Footprint Cleaning and Care Instructions:
Always make sure your tent is dry and free of debris before storing. Fold and roll your tent a different way each time to avoid permanent creases. Store in a cool, dry place. Never leave your tent in hot temperatures (such as a car trunk or attic space) for long periods of time, as it will damage the material coatings. Storing your tent damp can result in mildew growth, which may cause your tent to smell, leak, or delaminate. Mildew damage is not covered under warranty.
For light cleaning, sponge the product with warm water (not hot).
For more thorough cleaning you will need:
-Wash basin (or bath tub)-Warm water (not hot)
-Waterproof Gear Cleaner (we recommend products like Nikwax Tech Wash)
1. Submerge your gear in warm, clean water. Gently agitate with hands. Empty dirty water. Repeat until most of the excess dirt/grime is removed and water is mostly clear.
2. Apply waterproof gear specific wash and gently work into fabric with sponge.
3. Rinse gear thoroughly.
4. Hang it up to dry.
5. Triple check that your gear is completely dry before storage or use.
*Do not dry clean or machine-wash. Detergents and dry cleaning solvents will damage the fabric and ruin waterproofing.
*Never use hot water, bleach, liquid detergents, or dishwashing liquids.
*Allow to dry COMPLETELY before storage or use.
*Avoid prolonged direct sunlight as UV exposure can compromise waterproofing.
Big Agnes tents are seam sealed as part of our manufacturing process! This seam tape alone is durable enough to prevent water leakage. Any seams that have been taped do not need to be seam sealed with a liquid sealer unless you want extra protection. Make sure the seam-sealer is completely dry before re-packing your tent. Damage caused by misapplication may void warranty.
Keeping your zippers clean will help keep the coils and sliders from wearing out. If filled with dirt, vacuum or brush zippers before storing tent. We recommend Gear Aid Zipper Cleaner and Lubricant.
Repairs and Warranty:
All Big Agnes tents are guaranteed against manufacturing or material defect. We do not warranty products damaged from normal wear and tear, alteration made by owner, misuse, accidents or damages caused by uses other than intended. Damage due to misuse, normal wear and tear, or improper care may be repaired, at the discretion of Big Agnes, at a reasonable charge. Tents returned for repair must be clean and free of debris.
Questions? Call us or open a support case:
877.554.8975 | support.bigagnes.com
1. Remove contents from stuff sack. Spread out the tent body.
2. Stake out the four corners.
3. Assemble the three poles: two long poles and one short crossover pole. Be careful to insert each pole section by hand instead of allowing the shock cord to snap them together to ensure each pole section is fully seated.
4. Run the two long poles diagonally across the tent body crossing at the center. Insert the pole tips into the grommets at the four corners of the tent.
5. Attach the large clip located at the top of the tent body to the two long poles. The clip will fit over both poles where they cross.
6. Attach all plastic clips on the tent body to the long poles.
7. Insert the tips of the cross-over pole into the grommets, located above the doors on each side of the tent.
8. Drape the rainfly over the tent body aligning the color-coded webbing on the fly to the matching webbing on the tent body.
9. Insert the pole tips of the cross-over pole into the grommets, located on the underside of the fly above the doors on the fly. Each pole tip will be secured in two grommets one from the fly and one from the tent body.
10. Attach the Velcro® tabs on the underside of the fly to the corresponding poles for the best stability.
11. Make sure the webbing located at the corners of the fly is completely slack-ened. Attach the buckles on the fly to those on the tent body.
12. Tighten the webbing on each buckle as needed to keep the fly taut.
13. Stake out the vestibules then stake out all remaining guylines.
Separate 6” large diameter pole segment included for emergency field repair. Slide repair pole over the break to act as a splint.
HELPFUL HINTS FOR TENT SET UP
Our tents are easy to set up, but we suggest you practice once at home before using them for the first time to avoid late night bickering with tent mates while fumbling around in the dark.
Before pitching tent, clear campsite of debris that may pierce tent floor.
We recommend staking out all corners, vestibules and guylines to increase space and ventilation. Securely staking out your tent and all guylines is crucial to maintaining the structural integrity of your tent.
Hang onto your stuff sacks or they’ll blow away and create backcountry litter.
Pull on the pole sleeve fabric when inserting poles to avoid any bunching in the material.
Push rather than pull poles through pole sleeves.
Thanks for choosing a Big Agnes tent!
Please feel free to contact us if you have any questions or comments.
support.bigagnes.com | 877.554.8975